An EGR valve sends a controlled amount of exhaust gas back into the intake to lower combustion temperature and reduce nitrogen oxides.
What does an EGR valve do?
The EGR valve controls a passage that sends a small amount of exhaust gas back into the intake, where it lowers peak combustion temperature and reduces nitrogen oxides. It is an emission control device, not a power adder.
EGR stands for exhaust gas recirculation. EPA defines it as an element of design that reduces NOx emissions, which form at high temperature during fuel combustion. Recirculating exhaust gas reduces engine temperature and therefore NOx.
Why nitrogen and oxygen combine
Air is mostly nitrogen, with about 21 percent oxygen. Under ordinary conditions nitrogen is stable. EPA’s EGR training book says that above roughly 2,500 degrees Fahrenheit, nitrogen and oxygen can combine into oxides of nitrogen.
The recirculated exhaust is mostly inert. It has already been burned, so it does not add fuel to the charge. It dilutes the fresh mixture and absorbs heat, which pulls the peak flame temperature down. Less NOx forms at the lower temperature.
The valve is a metering device
The valve sits between an exhaust passage and the intake. Its job is to regulate how much gas crosses over. EPA’s training text says the amount must be controlled carefully. Too much gas at the wrong time can make the engine run rough or stall. Too little leaves NOx reduction on the table.
On the older systems in that text, the valve was normally closed and opened by vacuum. A coolant temperature switch blocked vacuum until the engine warmed. A ported vacuum tap opened the valve only as the throttle moved off idle. Modern engines replaced that plumbing with computer control.
How the computer decides
The engine computer commands the EGR valve using operating conditions such as engine speed, manifold pressure and temperature. Federal certification language lists engine speed, manifold pressure, coolant temperature and air charge temperature among the conditions that can carry a separate EGR calibration.
The OBD rule requires an EGR monitor as part of the onboard diagnostic system. EPA’s OBD questions and answers also list the EGR system among the components that must be monitored.
The service information for the engine defines the command, the feedback signal and the test values. A generic description cannot supply those numbers.
When the older vacuum systems allowed flow
| Operating condition | What the EPA training text describes |
|---|---|
| Cold engine | Coolant switch blocks vacuum, so no EGR |
| Idle | Ported vacuum is not exposed, so no EGR |
| Part-throttle cruise or acceleration | Vacuum opens the valve and EGR flows |
| Wide-open throttle | Ported vacuum drops, so EGR stops |
| Warm engine at light load | Vacuum bias reduces EGR to prevent surge |
The table describes the vacuum-operated systems covered in the 1977 EPA text. A modern computer-controlled system can schedule EGR differently. Use the table to understand the principle, not to test a late-model engine.
What a fault looks like
A valve held open can admit exhaust at the wrong time. The EPA text describes rough running and possible stalling when that happens. A valve that never opens leaves NOx untreated, even though the driver may notice nothing.
The check-engine light is a better clue than the seat of your pants. The OBD system monitors EGR flow and stores a code when the test fails. The code points to a circuit or a flow problem, not automatically to a dirty valve. The service manual’s EGR test decides what to replace.
Why removing the valve is not a repair
The EGR valve is part of the certified emission control system. The Kia manual says the vehicle should not be modified and that modification may violate governmental safety or emissions regulations. It also tells owners not to tamper with any part of the emission control system.
Federal law treats removal or defeat of an emission control device as tampering. The guide to why removing emissions equipment is illegal explains that rule. A driveability problem is a reason to diagnose the system, not a reason to delete it.
For the other exhaust-control device on the same engine, see what a catalytic converter removes. The Automotive Mechanical Systems hub covers the wider engine group.
Frequently asked questions
Does EGR reduce fuel economy?
EGR is fitted to control NOx, not to save fuel. The EPA describes it as a way to lower peak combustion temperature by recirculating exhaust gas. The engine computer still has to balance EGR with fuel and spark for driveability and emissions.
Can a bad EGR valve cause a rough idle?
A valve that allows too much exhaust gas at the wrong time can make the engine run rough or stall, according to EPA’s EGR training text. A valve that stays closed leaves NOx untreated; that text’s rough-running warning is about too much flow, not too little.
Is EGR used only on diesel engines?
No. EPA’s training book describes EGR on gasoline cars from the 1973 model year. Diesel engines also use EGR to control NOx, and EPA lists the EGR system among the diesel components that OBD monitors.
Can an EGR valve be cleaned instead of replaced?
Cleaning may be part of a repair, but the procedure and the decision belong to the manufacturer’s service information. Some deposits are removable and some parts are not serviceable. Deleting the system instead of repairing it is tampering.
