THE MOTOR ATLAS GUIDE

Towing a Boat With a Midsize Pickup

A midsize pickup can handle many boat trailers, but the loaded weight, tongue weight and hitch limits decide it, not the boat's length.

A midsize pickup on a launch ramp with a boat on its trailer behind it, and a bold downward arrow over the hitch showing tongue weight pressing down.

Match a boat and trailer to a midsize pickup's ratings, then handle tongue weight, hitch class, brakes, lights and the ramp with manufacturer guidance.

Quick answer: A midsize pickup can handle many boat trailers, but the loaded weight, tongue weight and hitch limits decide it, not the boat's length.

Can a midsize pickup tow a boat?

Yes, for many boat and trailer combinations, but the truck’s ratings decide it, not the boat’s length. A midsize pickup may be rated lower than a full-size truck, and ratings vary by engine, drivetrain, axle ratio and trailering package.

For 2026, Chevrolet lists the Colorado at up to 7,700 pounds of trailer weight with the 2.7L engine, four-wheel drive, the Trailering Package and the limited-slip differential, against a gross combination weight rating (GCWR) of 13,250 pounds. The ZR2 is listed at 6,000 pounds and 11,600 pounds GCWR.

Confirm the rating for the exact vehicle. The Colorado trailering features show how equipment changes the number.

Add up the loaded boat, trailer and gear

Brochures quote a dry hull weight that leaves out the trailer, fuel, batteries, anchors and gear.

Chevrolet’s 2026 Trailering Guide says the maximum trailer rating assumes a driver and front-seat passenger at 150 pounds each, plus all required trailering equipment. Extra people and cargo reduce the weight left for the trailer.

The combination must stay within four limits, so weigh the truck and trailer fully loaded.

Rating What it includes Where to find it
GCWR Truck, trailer, passengers, fuel and cargo together Owner’s manual; trailering label
GVWR Truck, passengers, cargo and tongue weight Certification label on the door jamb
RGAWR Load carried by the rear axle Certification label
Maximum trailer weight Heaviest trailer under the stated assumptions Owner’s manual or chart

The difference between the first two is covered in towing capacity versus payload capacity.

Tongue weight on a boat trailer can fall outside 10 percent

Chevrolet’s guide gives 10 to 15 percent of loaded trailer weight for a conventional trailer. It notes that boat trailers may fall outside that range, so the trailer owner’s manual should be followed instead. What is tongue weight explains the measurement.

Measure at the coupler with the trailer loaded. Tongue weight counts against the hitch rating, the truck’s payload and its rear axle rating. Loads placed too far forward or back can create sway at highway speed.

Match the hitch class and connection to the trailer

The trailering guide groups hitches by gross trailer weight and calls these classes minimum recommendations.

Hitch class Typical trailer Gross trailer weight
I Personal watercraft trailer Up to 2,000 lb
II Small speedboat trailer 2,001 to 3,500 lb
III Larger boat trailer 3,501 to 5,000 lb
IV Big boat or enclosed trailer 5,001 to 10,000 lb

The ball diameter must match the coupler, and its rating must meet or exceed the gross trailer weight. Colorado models have a 7-pin harness for trailer lighting and brakes. Cross the safety chains under the tongue, leave enough slack to turn, and keep them off the ground.

Before moving, check the hitch hardware, mirrors, chains, lights, tire pressures and the breakaway switch. Test electric trailer brakes with the controller at low speed.

Trailer brakes and lights before the first mile

Chevrolet requires trailer brakes above 1,500 pounds on models other than the Silverado, Suburban and Tahoe, and notes that state law may differ. Surge brakes, common on boat trailers, work through the coupler rather than a dash controller.

California is one example. Its vehicle code requires brakes on at least two wheels for a trailer with a gross weight of 3,000 pounds or more. Check your own state.

Confirm the running lights, turn signals and brake lights. Disconnect the trailer wiring before submerging it, unless the trailer has electric brakes designed to work underwater, as the guide describes.

Launch and retrieve with the ramp sequence in mind

Chevrolet’s guide says to have passengers leave before backing onto the sloped part of the ramp, and to lower the front windows in case the vehicle slides. If the ramp is slippery, the driver stays aboard with the brake pedal applied. Do not move if anyone is behind the trailer. Use 4WD High or Automatic 4WD if equipped.

Back down slowly only until the boat floats. Hold the brake, chock the front wheels, then apply the parking brake and shift to Park. To retrieve, start the engine, shift into gear, release the parking brake, remove the chocks, pull slowly, and shift out of 4WD High after leaving the slope.

Ohio’s launching and loading guide adds the parking-lot steps. Remove tie-downs except the winch hook, disconnect the trailer wiring, fit the drain plug and stow gear before taking a ramp lane. Ohio State Parks rules also require everyone but the driver to exit during launching and loading.

On the road, the guide says to select a lower gear before a long descent, use Tow/Haul or grade braking where fitted, and use firm, steady brake pressure. More trailering guidance is in Off Roading and Towing.

Frequently asked questions

Can a midsize pickup tow a 5,000-pound boat and trailer?

Possibly, but only if the loaded weight is below the truck’s maximum trailer rating and the combination stays within GCWR, GVWR and rear axle limits. A 5,000-pound trailer adds about 500 to 750 pounds of tongue weight at 10 to 15 percent.

Do boat trailers need their own brakes?

Chevrolet requires trailer brakes above 1,500 pounds on most of its models, and state rules can set a different threshold. California, for example, requires brakes on at least two wheels for trailers at 3,000 pounds gross or more.

Should I use four-wheel drive on a boat ramp?

Chevrolet’s guide says to place the vehicle in 4WD High or Automatic 4WD, if equipped, before backing onto the ramp. Shift back to the normal drive mode after the truck and trailer are off the slope.

How much tongue weight should a boat trailer have?

Chevrolet lists 10 to 15 percent of loaded trailer weight for conventional trailers, but says boat trailers may fall outside that range. Use the tongue weight stated in the trailer’s own manual, and confirm it with a scale at the coupler.

How this guide was prepared: Researched explanatory guidance using the sources linked on this page. We have not road-tested a vehicle or completed a hands-on inspection for this article. The displayed byline is a fictional editorial persona, not a real individual author or certified technician reviewer. Motor Atlas is responsible for this content. Confirm vehicle-specific procedures with the manufacturer, and ask an appropriate professional before safety-critical repairs, legal filings or financial decisions.

Related reading