Plan a towing trip around the loaded trailer: realistic driving days, grades, fuel-stop access, campsite fit and a repeatable hitch and brake check.
What should a towing road trip plan start with?
Start with the loaded trailer, then plan the route, the stops and the nights around what that combination can actually do. A plan built on an empty SUV’s range, pace and parking will fall apart on the first mountain grade or busy fuel station.
Chevrolet’s 2026 Trailering Guide covers loading, hitches, grades, passing, backing and a pre-departure checklist. The advice applies to any conventional trailer.
Two numbers set the ceiling: the trailer’s loaded weight and the tow vehicle’s ratings. The gross combined weight rating caps the vehicle, trailer and everything in them, and the trailer’s label gives its GVWR.
Before the first leg, confirm the tongue load too. The tongue weight guide explains how it is measured and why it counts against the SUV.
Set a driving day you can finish
Chevrolet’s guide says to apply gradual pressure on the accelerator, let the combination reach a comfortable speed, and allow extra time and room when merging. Braking needs extra distance too.
It also gives a following-distance rule: leave one vehicle and trailer length for every 10 mph of speed. At 60 mph that is six lengths.
Treat that gap as the pace-setter. A schedule built on car-like acceleration and stops will keep pushing the driver to close it.
Choose a route that respects grades and turns
Before a steep descent, the guide says to reduce speed and shift to a lower gear. It also says to crest a hill no faster than the speed you want to descend, so the combination is already slow when the grade starts.
Turns need their own plan. The guide notes that a trailer’s turning radius is typically much smaller than the tow vehicle’s, so a tight turn can put the trailer into a curb, a shoulder or a tree. It also says never to pass on hills or around curves.
Fewer blind crests, narrow switchbacks and tight urban corners are easier on equipment and driver.
Plan fuel stops you can enter and leave forward
Fuel stops are where trailer trips go wrong quietly. A station that looks open from the road may have a tight pump island, a low canopy or no room to swing wide on exit.
Use the distance-to-empty display as a guide, not a target, and plan the next stop before the warning light. Look for pull-through lanes and enough forecourt to leave without reversing.
The same logic applies to rest areas: park where the combination fits.
Book sites that fit the trailer
Airstream lists its Basecamp at 20 feet long, with a GVWR of 4,300 to 4,500 pounds and hitch weight of 508 to 535 pounds. That is a small trailer, and it still needs a site long enough for the trailer plus the tow vehicle.
Check the site’s stated length and hookup type before booking. A photo does not show the turn into the pad or the trees at the entrance.
Repeat the same check at every stop
Chevrolet’s checklist is a good template: hitch and platform, hitch nuts and bolts, mirrors, safety chains, and vehicle and trailer lights. Check tire pressure on both vehicles, confirm any required sway-control device works, test the electric trailer brakes at low speed, and confirm the breakaway switch is connected.
NHTSA says to check pressure at least once a month when tires are cold, using the vehicle’s tire information placard. On a trip, a cold-morning reading is the useful one.
Trailer equipment rules change at state lines. The Wisconsin DMV requires trailer brakes once the trailer and load exceed 3,000 pounds, or when the trailer outweighs the empty tow vehicle. Check the states on the route.
Know what to do if the trailer starts to sway
Chevrolet’s guide describes sway as instability of the trailer relative to the tow vehicle, often caused by poor weight distribution, too much speed or overloading. Crosswinds, maintenance and road conditions can also start it.
Its response is specific. Hold the steering wheel steady, release the accelerator without touching the brake pedal, apply the electric trailer brakes by hand if equipped, then use the vehicle brakes to stop. Trying to steer out of sway can make it worse.
After stopping, check the load for shifting and the tires for pressure and condition. If wind caused it, wait for better conditions.
The Off Roading and Towing hub collects the related guides on ratings, hitches and recovery gear.
| Check before each day’s drive | What to look for |
|---|---|
| Coupler and hitch | Fully seated, latched and pinned |
| Safety chains | Connected with enough slack to turn |
| Lights | Running, brake and turn signals working |
| Trailer tires | Cold pressure at the trailer’s specification |
| Trailer brakes | Apply and release smoothly at low speed |
Frequently asked questions
How many miles a day can I cover while towing?
There is no universal number. Speed limits, grades, traffic and fatigue all change it, so plan by hours and breaks.
Can I tow at the posted highway speed?
Not always. Chevrolet’s guide names speed as a major contributor to trailer sway. Check the posted signs and any lower limit that applies to your combination, and slow down in wind or poor surfaces.
How do I plan fuel stops with a trailer attached?
Look for pull-through lanes and room to turn wide on exit, and plan the stop before the fuel gauge demands it. A station you cannot leave forward is a poor stop, however cheap the fuel.
Do I need to book a campsite that fits the trailer?
Yes, when the campground assigns lengths. A 20-foot trailer plus a tow vehicle needs more space than the trailer alone, and photos rarely show the entrance turn.
