Test a car battery's voltage with a multimeter at rest and while running, then learn what a voltage reading cannot tell you and when to ask for a shop test.
How do you test a car battery with a multimeter?
Set the multimeter to its 0 to 20 volt range, let the surface charge drain, touch the probes to the battery posts and read the resting voltage, then read it again with the engine running. Interstate Batteries, a battery maker, describes this routine in its multimeter how-to.
The result is useful but limited. AAA Northeast says a voltmeter gives an idea of battery condition, “although it won’t give you the full picture.”
This guide covers a conventional 12-volt starter battery. For how long these batteries typically last, see how long a car battery lasts.
When to test a battery and what to check first
Test before problems strand you. The Car Care Council advises testing the battery every fall. It adds that a battery three years old or more may be worth replacing.
AAA Northeast recommends testing before every winter and summer. AAA Club Alliance lists signs of wear: dim lights, a slow or difficult crank, dashboard warning lights and a battery three to five years old.
Safety comes before the test. Kia’s battery page advises eye protection when working near a battery. It also says to keep flames and sparks away because the battery produces hydrogen gas, which can explode.
Interstate lists a swollen case, the smell of rotten eggs and a battery warning icon as signs of a bad battery. For the smell, it says not to go near the battery and to take it to a professional.
The test, step by step
Interstate’s routine has four settings or readings.
| Step | What to do | Reading or setting |
|---|---|---|
| 1 | Turn the headlights on for about two minutes, then off | Removes any surface charge |
| 2 | Set the multimeter range | 0 to 20 volts |
| 3 | Touch the probes to the posts, red to positive and black to negative | Resting voltage of around 12.5 V |
| 4 | Start the engine and read again | Higher than 13 V |
Find the positive post first. Interstate says it is usually red with a plus sign, and the negative is usually black with a minus sign.
The 12.5-volt figure is one maker’s number. Your battery’s maker may quote a slightly different one, so treat it as a rough marker, not a pass mark. Interstate itself says a reading near 12.5 volts “doesn’t mean you have a good battery.”
What the readings suggest
A resting reading far below the maker’s figure may mean a discharged battery. AAA Northeast says a drained battery needs a battery charger, likely for several hours. Driving for 30 to 60 minutes will usually not fully restore it.
A low reading with the engine running is a different clue. Interstate says that if the voltage stays lower than 13 volts, you could have a bad alternator or a bad battery. A multimeter alone cannot tell which. See how to recognize a failing alternator for related symptoms.
If the car will not start at all, a jump-start may get you moving. It does not explain the cause.
What a voltage test cannot show
A multimeter reads voltage only. It does not show how the battery performs when the starter demands power. That is why a battery can read near 12.5 volts and still fail.
Interstate says its advanced diagnostic test can tell whether a battery needs recharging, replacement or whether another system, such as the alternator, needs evaluation. It says its shops also measure reserve capacity. AAA Northeast says its mobile technicians test the battery and charging system with the latest equipment.
If your reading is borderline, or the car cranks slowly, ask a shop or roadside service for a proper battery test. If the test says replace it, read how to replace a 12-volt car battery.
Hybrids and EVs
Check the manual before testing. AAA Northeast says owners should never touch a hybrid’s high-voltage battery. Only the 12-volt battery is involved in a starter-battery check.
Some designs differ. The 2025 Kia Niro hybrid manual says the car has no regular 12V battery needing periodic replacement. It says the 12-volt battery is lithium-ion and integrated into the high-voltage battery. For a design like that, follow your manual instead of the conventional routine above.
More electrical jobs are in the DIY Car Repair hub.
Frequently asked questions
What voltage should a good car battery read?
Interstate says a resting voltage of around 12.5 volts, measured after the surface charge is removed. It also says that reading alone does not prove the battery is good. Your battery maker or manual may give a different figure.
What should the multimeter read with the engine running?
Interstate says higher than 13 volts. Lower than that could mean a bad alternator or a bad battery. A shop test can separate the two.
Can a battery pass a multimeter test and still fail?
Yes. AAA Northeast says a voltmeter does not give the full picture. Interstate says a reading near 12.5 volts does not mean the battery is good. A capacity test shows more.
How often should I test my car battery?
The Car Care Council advises testing every fall. AAA Northeast advises testing before every winter and summer. Test sooner if you notice slow cranking or dim lights.
